Just In another nubie needs help!!! - CNCzone.com-The Largest Machinist Community on the net!

04-20-2010, 04:33 PM

J.Ballantyne J.Ballantyne is offline

Join Date: Apr 2010

Location: Canada

Posts: 2

another nubie needs help!!!

permalink

Hi all im new to this site and need a little assistance ,we have a rover 3.40 with biesse works im not too bad at it, heres my dilema while doing single parts with oinon skinning the program works fine. however if i take that same prog.and nest it the depth becomes an issue there for i have to go in to EVERY line and change the final pass ANY HELP ??? thanks Jim B.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
real nubie	Jetpylot33	CNCzone Club House	0	11-05-2008 09:20 PM
Nubie G251 Assembly Question	rlrhett	Gecko Drives	14	09-29-2008 08:13 PM
DIY Nubie questions. learning as i go.	Revtech	DIY-CNC Router Table Machines	7	05-29-2006 08:07 PM
Nubie needs help	SPEEDRE	General Electronics Discussion	8	06-08-2005 03:28 PM

All times are GMT -5. The time now is 05:14 PM.