- North America Question about oxy/fuel torch controller
-
Registered
Question about oxy/fuel torch controller
Hello Folks... I currently use an old Lynx controller to move a single oxy/fuel torch head. All I need is an x and y axis as all I am doing with this unit is cutting squares and rectangles. My Lynx unit is on it's last legs and failure is immenent !
I have been looking at a replacement unit for this controller and have been in contact with a couple of suppliers... does anyone have any experience with the "Picopath" units, or the "machines in motion" units ? Alternatively.. can anyone give me a heads up on something else that I should consider ?
Thanks
Rod
Similar Threads:
-
- North America Question about oxy/fuel torch controller
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules