- Problem- G43 code in UPG
-
Registered
G43 code in UPG
Hi forum,
due to my setup Tool offset is redundant (et. problematic) so I need to strip it out of my post processor
for the life of me i have scoured the UPG to see where to remove it but not having much luck
any guides (BTW generic Fanuc used)
Similar Threads:
-
-
Registered
Re: G43 code in UPG
In the UPG go to sections, rapid moves, 1st rapid z down. Delete the <G:43>
- Problem- G43 code in UPG
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules