Need Help! CamWorks Chamfer On One Edge?


Results 1 to 2 of 2

Thread: CamWorks Chamfer On One Edge?

  1. #1
    Registered
    Join Date
    Feb 2017
    Location
    United States
    Posts
    0
    Downloads
    0
    Uploads
    0

    Default CamWorks Chamfer On One Edge?

    Hello,
    I am trying to cam up a part in CamWorks and I am having some trouble with my chamfer feature. All of the examples I found online setup the chamfer as a part perimeter. I only need it to go along one edge but I can't seem to properly set it up. I have also tried doing a surfacing operation but with no avail. Below are some screen shots of my part. I am fairly new to CamWorks so any help is greatly appreciated. Thanks!



    Similar Threads:
    Attached Thumbnails Attached Thumbnails CamWorks Chamfer On One Edge?-cam-shot-2-jpg   CamWorks Chamfer On One Edge?-cam-shot-1-jpg  


  2. #2
    Registered
    Join Date
    Feb 2017
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: CamWorks Chamfer On One Edge?

    Open Profile is the feature that you will need for this.

    It also looks like you don't have a good edge to grab directly and will need to come off of a sketch.

    Last edited by SteamNinja; 02-23-2017 at 02:53 PM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

CamWorks Chamfer On One Edge?

CamWorks Chamfer On One Edge?