Camworks Turning / Lathe and Tool BCA

[snippitysnap]

Camworks 2001 plus

I am new to using Camworks for turning, however I am very experienced with in in milling.

I notice that the AFR in turning uses feature back clearance angle.

But I dont see where you can actually store an insert+holders back clearance angle anywhere.

So is this just a matter of setting up the AFR to pick tools you "know" have the right BCA for a given BCA range, but you never actually put the BCA number in anywhere?

Thanks for any help!



Similar Threads:

• Turning - One Tool for drill and inside turning?
• Need A Quote- Lathe turning tool holder set largest and oldest manufacturer
• VERY NICE WEILER 22-2800 RPMS TURNING TOOL ROOM LATHE 3 PHASE 240 VOLTS
• Does this lathe turning tool bit exist?