Are you affiliated with camworks?
If you need a new post or need changes in your post I coud help you.
2-3 axis millng
4-5 axis milling
turning
Millturn
EDM
Similar Threads:
Are you affiliated with camworks?
Qkay, they tend to be "spammy" and difficult to work with, "fill in this form" emails till I batch delete, "here's a new offer", ect...
NO troll intended, just curious.
Hi, I´m Post developer, and I can say that turupio is one of the best professionals that I know developing postprocessors for CAMWorks / TekSof.
If you need a post for Camworks I´m sure that he could help you.
is it possible to get a good post processor for Camworks for a Haas VF2 with 4th axis what I notice mine doing is that when it does finish contour it doesn't have "A' movement where I think it should be not to mention that it isn't even starting in the right area
this is how I think it should be
G00 G54 X.0021 Y0 A-.818
G43 H01 Z1.4031/ M08
this is how it is
G54 G41 D35 X.087 Y0
G43 H15 Z2.3031/ M08
for some reason it just isn't right.. tried a few different post nothing seems to solve it so I just ran the rough contour which was right with no material left for finidh contour
hope it makes sense
any help is always appreciated
Bernard
bhoweth@jainsusa.com
Hi cruizer. I just send you an email with the details.....
Hi,
I could use a bit of help. I have a converted machine that does not have limit switches. Is there a way to remove the g28 zero return reference? Currently I have to remove them manually otherwise it'll jog to infinity and beyond.
I bypassed that issue by setting up G54 0,0,0 as the new machine coordinates and use G55 for the part work offset. That allowed me to reference the mill at the zero point I wanted in G54, and used those coordinates to send the mill to for tool changes. I usually set the x and Y zero same as the part x and y zero and g54 has the z axis at full height.
Turupio,
Your message box is full!
Sent from my XT1080 using Tapatalk
Private message sent!
Sent from my XT1080 using Tapatalk
icvette your messages box is full
Lol... Going to clean out now
Sent from my XT1080 using Tapatalk
Fixed
Sent from my XT1080 using Tapatalk
Hi, If someone need a help to develop CAMWorks post, program part or learn to use CAMWorks options you can contact me.
Regards,
Hi Turupio
I know this is an old thread but if you are still around I need help locating a Fanuc Wire Edm (W1 Series) Post for Camworks.
Can you help?
Krispee