| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CamSoft Products Discuss Camsoft PC based CNC controller products here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-15-2005, 07:47 AM
| |||
| |||
Ok.. I was bored... It all works great... the buttons turn red yellow and green to indicate function and status.. The lift in the middle moves back and forth over the little green boxes and they also turn colors to indicate function and status. I had to blur a few things out for obvious reasons. Comments?  Last edited by CNCadmin; 04-15-2005 at 07:53 AM.    |
|
#2
04-15-2005, 08:50 AM
| ||||
| ||||
| Looking good! I trust you also have a hardwired in E-Stop as the screen operated one does not conform to the safety code. Al
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
04-15-2005, 10:05 AM
| ||||
| ||||
| hmmm wonder if safety codes apply to hobby cnc's?  |
|
#4
04-15-2005, 10:22 AM
| ||||
| ||||
| I don't think it's a "hobby" machine. http://www.cnczone.com/gallery/showg...&condition=and
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#5
04-15-2005, 06:25 PM
| |||
| |||
Estops are all hard wired and will cut power to the drives when activated... I dont trust enable circutes or digital logic. Murphy |
| Sponsored Links |
| |
|
#6
04-15-2005, 06:27 PM
| |||
| |||
Hobby what??? who?? This is no hobby machine that's for sure!! Its slightly larger than 2 semi truck trailers. That's one heck of a hobby!! LOL Murphy |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with LPT Stepper Interface | nickleplated | Stepper Motors and Drives | 5 | 06-08-2005 08:28 PM |
| Computer to drive interface | CRFultz | General Electronics Discussion | 2 | 04-25-2005 11:45 AM |
| A peek at my new interface... | murphy625 | CamSoft Products | 4 | 04-08-2005 06:55 PM |
| Operator Interface Blues... | murphy625 | CamSoft Products | 11 | 03-31-2005 08:07 PM |
| pc to driver interface | wired | General Electronics Discussion | 3 | 01-06-2005 07:52 PM |
| | |
Linear Mode
