| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CamSoft Products Discuss Camsoft PC based CNC controller products here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-07-2005, 03:12 PM
| |||
| |||
I am trying to find out jumper settings to inhibit Fanuc drives using a Camsoft/Galil 1840 motion control card with a 1900 I/O connection breakout box. The drive # for the jumper settings is A06b-6035 class and the top board is A20B-004-017. Anyone with any information on the jumper settings would be very helpful.    |
|
#2
03-07-2005, 06:43 PM
| ||||
| ||||
| Are you refering to the enable pin on the drive connector? I have the Honda plug pin out for the CN2 connector on A06B-6045 drive, the enable pin on these is pin 2 (enbl), the 6045 might be the same. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
