| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CamSoft Products Discuss Camsoft PC based CNC controller products here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-24-2004, 08:35 PM
| |||
| |||
Does anyone know if the RS232 DMC1500 series controllers are supported in Camsoft?    |
|
#2
08-24-2004, 09:31 PM
| ||||
| ||||
| AFAIK Camsoft only use the PCI or ISA PC bus interface in their system. Al
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
08-25-2004, 11:17 AM
| |||
| |||
| Squarewave, While, we do offer RS232 controllers, we do not recommend the DMC 1500 for CNC use, because it is too slow and has been discontinued by Galil years ago. We also offer a variety of models for EtherNet, as well as what Al mentioned the PCI and ISA versions. Take a look at these plus the low end 4 axes RS232 DSP based motion board at: www.cnccontrols.com/motionboards.asp Tech Support CamSoft Corp. (951) 674-8100 support@camsoftcorp.com www.cnccontrols.com
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Last edited by CNCadmin; 08-25-2004 at 11:54 AM. Reason: To comply with policy. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
