| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CamSoft Products Discuss Camsoft PC based CNC controller products here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-27-2008, 09:04 AM
| |||
| |||
Has anyone erve recieved a Time Out error (L10-2112 or L10-16945) while using the handwheel? The message "There may be a conflict with the card address or a registered Galil driver. Use the Galil Reg.Exe program to correct" comes on the screen. I spoke with Galil, and they said it is not their error. It must be in Camsoft. The control works fine otherwise, but when you go into a low pulse count in the "Y" axis (.001/div) this error will come up after traveling approx 2.5 inches. If I feed the axis in the tach mode, there is no problem. Thanks.   |
|
#2
03-27-2008, 10:11 AM
| |||
| |||
| toolmanwaz, It's not our message either. We can't even venture guess what these numbers mean. It must be related to Windows or a hardware driver that the hand wheel use to interface with. Send us a bitmapped screen shot with a LOGFILE.FIL file to support@camsoftcorp.com Tech Support CamSoft Corp. support@camsoftcorp.com PH 951-674-8100 Fax 951-674-3110 www.cnccontrols.com
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mach with Galil or Delta Tau? | TurboStew | Mach Software (ArtSoft software) | 10 | 10-21-2008 09:45 AM |
| Galil question and others | jimc | Servo Motors and Drives | 33 | 06-13-2008 09:25 AM |
| Yaskawa & Galil DMC 730 | ChiTownTech | Linear and Rotary Motion | 2 | 11-06-2006 09:41 PM |
| Galil Anyone | Al_The_Man | Servo Motors and Drives | 48 | 10-29-2006 01:52 PM |
| Sure Servo to Galil | Mountain | CamSoft Products | 7 | 07-05-2006 12:40 PM |
| | |
Galil Error L10 
Linear Mode
