| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CamSoft Products Discuss Camsoft PC based CNC controller products here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-21-2003, 10:50 PM
| |||
| |||
What brand dc brush servo amps work best with Camsoft software and Galil motion control boards? I believe that they should be used in torque mode.    |
|
#2
12-22-2003, 12:09 AM
| ||||
| ||||
| Hi, I have used A-M-C, Copley Controls, and Aerotech, you are right to use them in the torque mode, one thing to watch in the torque mode especially if the tach feedback is now no longer used is to make sure the amplifier is disabled on power up until the motion card is ready, and the same with power down, disable the amp before removing power to the Galil card. This prevents sudden servo motion under these conditions. The majority of current DC amps will work that have the +-10 analogue command. even in the tach feedback mode. Al
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Small servo systems and power supply | imserv | Product Announcements & Manufacturer News | 4 | 04-03-2008 12:11 PM |
| Using surplus servo motors as spindle drive | Swede | Servo Motors and Drives | 11 | 03-16-2008 09:05 AM |
| Servo Motor Running away. | murphy625 | CamSoft Products | 38 | 02-27-2005 02:08 PM |
| buzzing servo | harvard5 | Bridgeport and Hardinge Mills | 3 | 08-17-2004 08:42 PM |
| steppers or servo drives | mmjpotter | Gecko Drives | 14 | 03-30-2004 03:56 PM |
| | |
Linear Mode
