Results 1 to 3 of 3

Thread: electronic keyboard

  1. #1
    Registered
    Join Date
    Jan 2007
    Location
    USA
    Posts
    168
    Downloads
    0
    Uploads
    0

    Smile electronic keyboard

    I ran across this web site www. electronickeyboards. com
    I was wondering if this would be a good choice for a nasty shop environment?
    they have some industrial controller boards already set up that would make a neat control board. On Cam soft, how many keyboards could you have connected, like a seperate numeric, alphabet key board and maybe some arrows for jogging?
    Thank You
    The Farmer

    Industrial NEMA 4 Keyboard from EKI with lifetime Warrantee posts - 2 authors
    Rugged Industrial keyboards that will not wear out, rated at 30000000 touches per year. EKI's industrial keyboard detects your finger optically so there are ...
    Industrial NEMA 4 Keyboard from EKI with lifetime Warrantee $169 - Cached - Similar


  2. #2
    Registered Karl_T's Avatar
    Join Date
    Mar 2004
    Location
    Dassel,MN,USA
    Posts
    1363
    Downloads
    0
    Uploads
    0
    Looks like a nice keyboard. Better be, its cost is the same as sixteen of the ones I use. I treat them as disposable, they get dirty keys - just toss.


  3. #3
    Registered Mbock's Avatar
    Join Date
    Sep 2010
    Location
    USA
    Posts
    9
    Downloads
    0
    Uploads
    0

    Smile

    We use the flexible cheaper keyboards here. They are sealed and don't have problems until there gets a crack alongside one of the keys then we do like Karl does, Toss and use a new one.


Similar Threads

  1. engraving on OC keyboard ..
    By CNCpatriot in forum General Laser Engraving & Cutting Machine Discussion
    Replies: 25
    Last Post: 02-03-2011, 07:08 PM
  2. Centurion V keyboard
    By Sapper06 in forum Milltronics
    Replies: 2
    Last Post: 08-17-2010, 09:47 AM
  3. Problem- CNC VMC keyboard problem.
    By Benkerst5278 in forum CNC Machining Centers
    Replies: 0
    Last Post: 07-20-2010, 07:22 PM
  4. Problem- keyboard,,
    By billwe in forum Haas Mills
    Replies: 3
    Last Post: 04-28-2008, 09:57 PM
  5. keyboard jog
    By HuFlungDung in forum CamSoft Products
    Replies: 26
    Last Post: 06-08-2004, 10:17 PM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.