| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CamSoft Products Discuss Camsoft PC based CNC controller products here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#25
 
06-13-2005, 11:55 AM
| |||
| |||
Just a thought (not sure if this has been mentioned yet) Check to see if you have a screen saver or windows hybernation enabled. These two modes may drain computer voltage to below 4.7V that the motion card needs to operate. These two modes simply consume too much power on the system. intrusion  |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Linear Motion FAQ | Cutters Cove | DIY-CNC Router Table Machines | 6 | 09-30-2009 01:36 AM |
| Series 2 BOSS 6 Axis motion problem | craig96us | Bridgeport and Hardinge Mills | 43 | 01-14-2006 11:06 AM |
| TurboCNC with PC Motion Card?? | Al_The_Man | TurboCNC | 3 | 03-06-2005 03:41 PM |
| MaxNC motion kit for Sieg X3 mill? | replicapro | General Electronics Discussion | 3 | 06-16-2004 12:24 AM |
| A little help in fitting motion to a Minitech Minimill3 | nicad | Benchtop Machines | 6 | 03-23-2004 11:14 AM |
| | |
Linear Mode
