| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CamSoft Products Discuss Camsoft PC based CNC controller products here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-25-2005, 07:28 AM
| |||
| |||
Hi guy's I have installed the camsoft proffessional controller in one of our Plasma/Gas cutting machine. But I have observed that the controller is not taking care of kerf in anticlockwise circular profile. Machine is compensating the kerf in lall inear profiles But when any circular profile is programmed it simply ignore it. Do you people have any solution then reply.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using Camsoft on a Pratt & Whitney Tapemate C | jevs | CamSoft Products | 22 | 03-19-2007 07:11 AM |
| Taig Mill, US Digital MS23, Controller??? | marjamar | Taig Mills & Lathes | 3 | 02-07-2007 10:16 AM |
| Open Source CNC Controller Specification | gregmary | DIY-CNC Router Table Machines | 28 | 12-04-2005 10:58 PM |
| What's this USB Jog Stick Controller CamSoft has? | Bob Pierre | CamSoft Products | 1 | 01-08-2004 11:27 AM |
| | |
Linear Mode
