When I run a program in Camsoft the program will stop because my amp enable "#21" state changes from 0 to 1 and the 1 to 0 on its own, is this the Galil card itself shutting down and then back on again halting my program?
In my logfile motion stops after it says #21=0 servo on then a couple of lines later it will say #21=1 servo on
I wonder if I should reinstall my camsoft and galil software because my camsoft software takes a long time to respond to normal actions sometimes and then just locks up and I have to end the program just to exit. I also have a camsoft pendant and it also takes a long time to respond most of the time. What seems strange is if I had problems with wiring then why would all of my inputs and outputs when in diagnostics mode operate correctly. To help narrow the search I turned off all of my limit, inputio, startup.fil etc. and turned on diagnostics and tried my homing program and when it stop exited camsoft and looked at the logfile and have noticed motion stopped after seeing that the state of #21 changed and then changed again. I will look at the wiring and see if we are having problems there and then move on.
Sounds like you may have multiple issues driving you nuts, short trip for me
Start dividing the problem in two, is it hardware or software? Tie that input to + voltage, does it still happen? try again tied to ground.
I'd go nuclear with that computer: Reformat, install OS (I think Win XP SP1 is best NO virus NO internet), install only Camsoft. Use a new .cbk, not your old one. problems go away?