Engraving/Milling with CamBam

[GeorgeRace]

Just a few words to brag about some of the stuff I am doing in CamBam. Incidentally, I am using a 25 X 14 K2NC Mill that I put together and doing the work with MACH3.

I have been trying to do some nice engraving but just cannot get the results that I want. Started playing around with CamBam and discovered it would do exactly what I wanted, but not by engraving but by milling. You can take a look at my web site, http://www.mykitairplane.com and see the kind of stuff I am turning out. Take time to look at the Aircraft Data Plate, that is the final result of learning how to use CamBam to do a beautiful .15 inch lettering job. It is the best I have found for this kind of application.

If anyone needs to know more about how I am doing it I would be happy to share the settings I am using in one of the MOP's. It takes just a little over an hour to make that Data Plate. I start the process, go have coffee, and come back to a beautiful finished product.

It does not get any better that that!

George