single part selection from drawing

[wantsout]

If I want to select a single part drawing from a multi-part file drawing in cambam how do i do it and then create the g-code from it. IE ( shark.DXF)

I want to select just a single body from that file drawing and creat the g-code file from that selection only. Or any multi-part drawing for that matter... thank you guys so far you guys have been very helpful....

[Bertram]

Select the part

Create a MOP (profile, engrave, pocket etc.)

Right click on the MOP and select Generate Toolpath

Right click on the MOP and select Create Gcode File.

Save g-code file.



If the part requires more than one MOP, then right click on Machining in the tree view and select Create Gcode File, then save.

[wantsout]

Thank you very much, Im going to try that. again you guys are very helpful