| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CamBam Discuss CamBam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-11-2007, 12:55 AM
| |||
| |||
I downloaded the file trex from this site and I want to thank the person who uploaded it for other users. But my problem is my table travel is smaller than what cambam spit out for the g-code. so I tryed to select each section thinking it would configer the g-code smaller,but it didnt. If I explode the file while its still a dxf file will this allow me to select each section (leg,head,ribs,ect) so I can cut each as a seperate unit. and I want to use some scrap too. or how can I scale down the drawing. thanks    |
|
#2
10-14-2007, 03:50 AM
| ||||
| ||||
| Hi there wantsout, Sorry for not replying sooner...I've been flatter out than a lizard drinking here. I just replied to a similar question on the CamBam forum here http://www.forum.cambam.org/index.php?topic=153 I hope that helps a bit. Good luck! |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| oxy gasoline cutting torch - oPetrol cutting torch | denniswang | Product Announcements & Manufacturer News | 6 | 02-20-2010 05:23 PM |
| Have you ever machined Trex Decking? | Miata2k | Glass, Plastic and Stone | 1 | 10-18-2006 06:43 PM |
| I need help about cutting heads which apply to apparel pattern cutting machine | sheepgrass | Mechanical Calculations/Engineering Design | 0 | 05-12-2006 02:09 PM |
| Cutting tip | owhite | Laser Engraving & Cutting Machines | 6 | 04-27-2005 04:22 AM |
| | |
Linear Mode
