On/off commands for an engraving laser

[Dr.Jerryrigger]

Hello,
I have been playing with the CamBam demo and it has been really excellent for my uses. But I haven't figured out if there is a way to have it put m03 or m05 between each cut. I've been doing it manually, but I'd rather not have to if there is a way.

Similar Threads:

• Rabbit RL_6040 Laser engraving/cutting machine Rabbit RL_6040 Laser engraving/cuttin
• Newbie- Chinese Laser Cutting and Engraving Machine TS-6040 60w - Engraving problem
• Distinction between laser engraving between special LGP engraving machine when produ

[atwooddon]

You could do this by modifying the Post Processor. You will get a more detailed answer if you ask your question on the CamBam forum. Great (and very quick) support there for about any challenge you may come up with using CamBam.

CamBam - Index

Don

[Dr.Jerryrigger]

You could do this by modifying the Post Processor. You will get a more detailed answer if you ask your question on the CamBam forum. Great (and very quick) support there for about any challenge you may come up with using CamBam.

CamBam - Index

Don

Thanks Don,
I didn't realize they had a forum, good to know!