cambam trial only 500 lines of code? even in first 40 uses?

[effimos]

I have downloaded cambam a few days ago and on the website it says that in the first 40 trials the program is fully functional and that after the first 40 uses you can still use it but with a 500 code line limit.

But my trial already gives me a 500 lines limit in my first 40 uses and isnt fully functional at all!?

Does anyone lse have this problem.

[flojor10]

I have downloaded cambam a few days ago and on the website it says that in the first 40 trials the program is fully functional and that after the first 40 uses you can still use it but with a 500 code line limit.

But my trial already gives me a 500 lines limit in my first 40 uses and isnt fully functional at all!?

Does anyone lse have this problem.

No offence but it seems like you've been having a lot of problems. I would try uninstalling it then reinstall it. Make sure your using the safe version and not the beta because it is known to have problems like this. Best of luck

[blowlamp]

If you're loading the G-code into an unlicenced version of Mach 3, then you will be restricted to 500 lines by Mach 3 anyway.

Could that be the problem?


Martin.

[effimos]

If you're loading the G-code into an unlicenced version of Mach 3, then you will be restricted to 500 lines by Mach 3 anyway.

Could that be be the problem?


Martin.

that coud indeed be the problem! i didn't think about this but now that you say it. the g-code does fully load in mach3 but he only makes the program run for 500 lines.
i didn't know that, i thought the mach 3 version delivered with my controller was the full version but it's probably not.