Need Help!- TNC-155 Postprocessor to CamBam

[ab_seaman]

Hello everybody.

I have a little bit of problem I think you might be the people to help me with.
Does anyone have a postprocessor for Heidenhain TNC-155 they might be willing to share with me?

Sorry for the bad english but I´m from Sweden.


You might answer here or directly to my e-mail.

Thanks all!

torbjorn.l.mattsson@gmail.com

[Desertrunner]

I haven't heard of one being aviable, what you can do is try to get a list of the GCode that you control software will understand then compare it to what CamBam existing different post processors will handle till you find one that suits as close as possiable.

I am sure then some of the guys on the CamBam forum could help you from there.
Tony

[ab_seaman]

Thanks for the reply man.
Already try to find a postprocessor via the cambam forum but diden´t get any replies there.
Try to work out according to your suggestion.

Have a nice day

[blowlamp]

Someone has just come up with a postprocessor for a Heidenhain TNC-151 if that's any good for you.

See here: Heidenhain 151 post


Martin.

[ab_seaman]

Thanks for the tip.
Will check into that during the week.

//Tobbe