Problem- Island Pocketing Problem

[grandpa jay]

I have 2 dxf files that will not properly Island Pocket. I think that the problem is in the dxf file, as I have several other files that work fine. The txt file is cambam. Thanks for any help.
Grandpa Jay

[10bulls]

Originally Posted by grandpa jay I have 2 dxf files that will not properly Island Pocket. I think that the problem is in the dxf file, as I have several other files that work fine. The txt file is cambam. Thanks for any help. Grandpa Jay

Hi Grandpa,

If you select the outer rectangle and look at the properties you will see that Closed is False (You can just make out a little gap at the bottom).

If you change the Closed marker to True you should be good to go!

(And a fine looking woman I might add! )

[grandpa jay]

Thank you, I will give it a try in the morning.
Thank you again.
Grandpa Jay

[blowlamp]

Your drawing shows perfectly, why they invented nurbs.

Martin.

[grandpa jay]

The only thing that I could find in the drawing was the polyline was not closed. After closing the begining and ending point of the polyline are still off by .005" when listed. But it worked.
Grandpa Jay