| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CamBam Discuss CamBam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-19-2010, 12:48 AM
| |||
| |||
I've been having a weird problem with one unwanted arc. Well the arc is wanted, but for some reason it starts offset on the first pass, then corrects itself on the second pass. All which can be seen here Also in Mach 3 I'm getting a pop up message at the bottom that says something like Start point of arc has the same value as ending Line 42 Any help would be greatly appreciated ! I'm running this on a Tormach PCNC 1100 Series II with the Tormach's Mach 3 configured computer if that helps. Here's the thread I've started. http://www.cambam.co.uk/forum/index.php?topic=1177.0  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crop Circles are... | stevespo | BobCad-Cam | 67 | 10-22-2009 04:32 PM |
| Need Help!- More crop circles, and turning question | seanreit | BobCad-Cam | 8 | 11-20-2008 03:43 PM |
| Build Thread- Crop circles and the Chain Gap setting | Claude Boudreau | BobCad-Cam | 1 | 08-05-2008 09:35 PM |
| Crop circles | MrWild | Dolphin CADCAM | 7 | 03-17-2008 02:17 PM |
| Engraving, Tangentail arcs, and crop circles | Prboz | BobCad-Cam | 4 | 06-28-2007 08:06 PM |
| | |
Linear Mode
