| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Calibration & Measurement Discuss Calibration & Measurement here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-11-2009, 08:35 PM
| |||
| |||
hi, i am trying to rigg up somthing for finding edge i have a probe i took ans soldered a wire to it and it goes in my end mill holder and hooked it to 5v then took a clip that hooks to my work piece and it is hooked to pin 12 on bob right now i just have it were it triggers a estop when it touches how do i make stop when it touches with out triggering e stop thans ben  |
|
#3
02-12-2009, 07:06 PM
| |||
| |||
| mach 3 |
|
#4
02-12-2009, 07:18 PM
| ||||
| ||||
| OK, somebody who knows (maybe Hoss or others) Mach can lead you through the setup. I think he has a video on how to do it. I don't use Mach so don't want to mislead you! Good luck as this is a very handy tool to have in your box.
__________________ Art AKA Country Bubba (Older Than Dirt) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My DIY Edge Finder | multiplex | DIY-CNC Router Table Machines | 40 | 05-25-2010 11:46 AM |
| Edge finder | davehall | General Metal Working Machines | 1 | 09-28-2008 07:24 AM |
| Edge finder | eggo | Australia, New Zealand Club house | 3 | 08-04-2008 10:57 AM |
| Has anyone used this edge finder? | l u k e | General Metalwork Discussion | 34 | 03-19-2008 01:52 PM |
| Where to specify edge finder diameter? | JMFabrications | Haas Mills | 7 | 07-19-2007 12:04 AM |
| | |
Linear Mode
