EZ PATH I electrical chart - HELP

[mir_g]

Hello everyone ! I’ m new Kid on the block. I have problem with my Bridgeport/ROMI Lathe. At the beginning I had “1019” ( spindle drive alarm) and 1022 ( emergency stop) critical messages. After short reset lathe was running normally. Currently lathe is totally broken Unfortunately I haven’t electrical chart to this machine. I would be appreciate for copy of this chart and for advices to resolve this problem .
Thanks’ a lot !

mir_g@wp.pl

[Machineblues]

I have no electrical prints for your machine. It sounds that there may be a loose connection. Check all connections in and out of the electrical cabinet. Also tell the model of EZ-PATH you have it will help you get the correct wiring diagrams. I think the made many different models of this control.

[mir_g]

Hi. My lathe that ROMI EZ-PATH S Year of production 1998 ( SN.:002-083120-363) GE Fanuc 20-T
Nowadays, lathe is running, but without high speed of spindle. I'm still looking for the reason.

with best regards

[mir_g]

Hello everyone!
I captured the electrical chart for my lathe The lathe is almost O.K