I have managed to find a supplier of updated software for my Bridgeport EZ-PATH S. This includes the DOS disk and the machine software - does anyone know the install procedure?
thanks
Blod
I have managed to find a supplier of updated software for my Bridgeport EZ-PATH S. This includes the DOS disk and the machine software - does anyone know the install procedure?
thanks
Blod
Depends on what you have.
Usually I "nuke" the flash memory. There is special software for that by M systems. It is on a floppy that cannot be locked because it reboots a couple of times loading different things including loading basic minimal DOS. This is followed by the machine software, followed by a parameter disk.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Only source I would use is EMI-inc.net. You get procedure and support.
Get a DOM for the software.
And get DOS for dummies.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
thanks