| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-22-2010, 09:56 PM
| |||
| |||
I've looked around and found a few different wiring diagrams for wiring a Gecko to the original Sigma motor. I looked at this one, is Pin 3 = A, Pin 4 = A-? I think the resistor was a .8 ohm? Thanks for the help, Ron  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gecko G203v and a 1200 oz stepper --4th axis | woodman08 | Gecko Drives | 0 | 10-08-2009 08:52 PM |
| sigma motor ? | fido | Bridgeport and Hardinge Mills | 0 | 01-15-2009 01:22 PM |
| My Gecko G203V heat sink set up | Grebbo | Gecko Drives | 18 | 05-01-2008 09:29 PM |
| X3, Gecko G203V and what else.... | KOS | Benchtop Machines | 10 | 05-27-2007 10:08 PM |
| Sigma Vs. Superior on Gecko 202 | arriflex | Bridgeport and Hardinge Mills | 2 | 10-12-2006 04:28 PM |
| | |
Linear Mode
