I have just replaced the 486DX motherboard in my Bridgeport EZ-Trac and purchased a new 256mg Disk on Module preloaded with ver 3.8 software
It starts to load doing a countdown BMDC-19 down to BMDC-0.
The next message is: "Reading Param File" followed by message: "System Error - Possible Pointer Error.
Then it gets ugly.
Last message reads: "GP Fault - Fatal Error - The software will try to exit to clear the error"
A this point the hitting enter repeats the previous steps and errors in a loop.
The bios has no LBA or cashe memory on exit settings.
Is this a common problem with a fix?
Any time a BMDC counts down to zero, it did not load. High probability the BMDC might be bad. Clean the edge connector with a soft eraser. Check your logic power supply
General protection faults come from the mother board.
Did you set the CMOS for the DOM?
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)