backing up parameters - CNCzone.com-The Largest Machinist Community on the net!

robinhood2b · #1 09-23-2009, 04:54 PM

Hi can somebody tell me how i go about backing up my machine parameters to my pc.
I have a interact 1 mk 2 with a heidenhain tnc2500 controller and run tnc remo software.
i wish to back them up as i have just been caught out on another machine a fanuc wire eroder which i had not backed up and now know what a pain it is to lose them.
many thanks
mark

gus · #2 09-23-2009, 07:26 PM

not sure on that exact control[manual on heidenhain.com] but 95148 and ext is a start.

kongzai · #3 09-30-2009, 10:31 AM

press Mode until u get into Code Number: . Key in 95148, enter, prepare ur dnc linking, press the button EXT to send them all into ur pc. Thats all u need for parameter backup.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Backing Up Parameters? (OSP700L)	H234	Okuma	5	10-10-2009 01:35 AM
Backing up Control Parameters & Settings on VF3 1998	Rocko1	Haas Mills	3	02-03-2009 11:40 AM
Need Help!- Z not backing off home switch	Ferny	Mach Software (ArtSoft software)	3	02-11-2008 10:29 PM
fabrication of 50's radio hdf backing	consciousness	WoodWorking	3	10-09-2007 09:07 PM
Backing Plate	davidlee	Welding, Brazing, Soldering, Sealing	1	02-08-2007 10:14 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)