Bandit Control ? - CNCzone.com-The Largest Machinist Community on the net!

jdelaney44 · #1 03-03-2005, 09:44 AM

George, you mentioned that the Elrod rig looked like a Bandit. I did some searching on Bandit. Narrowed to Bandit I, but I didn't find any good pictures of machines with them, yet. Found one at a distance. You can see it's a box with a motor to the right mounted to the front of the head, but that's about all unfirtunately.

If you happen to run across one, could you let me know? Sure would appreciate it. Thanks for the reply by the way.

-jd

machintek · #2 03-03-2005, 09:15 PM

I am going back over 20 years when I say I saw one. I will keep looking at Ebay. I just copied some pictures of a Series 2 NC with a C-5 CNC option from Ebay. The machine did not look used and the pictures were very very good.

George

jdelaney44 · #3 03-04-2005, 12:38 AM

OK, thanks. I'll keep looking. Just wondering what it looks like really. Shopping for other ideas.

-jd

jdelaney44 · #4 03-06-2005, 09:36 PM

Found somw pics from e-Bay of the Bandit Z-Drive

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
G-Code to DXF	WayneHill	OpenSource Software	189	01-30-2012 11:15 AM
Visual Basic Controller Project	dwwright	Visual Basic	29	02-14-2011 02:24 PM
Bandit Control	DieGuy	General CNC (Mill and Lathe) Control Software (NC)	1	02-05-2011 09:17 PM
CNC Glossary	CNCadmin	CNCzone Club House	17	03-09-2008 04:08 PM
HAAS Indexer Prodramming / Control	CAMmando	Haas Mills	8	06-10-2003 11:22 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)