| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-21-2009, 11:06 AM
| |||
| |||
Would someone have pages 7-3 and 7-4 from the Series 1 Boss 9 R2E4 maintenance manual? My BSP green LED is not lit signifying no 5v and I need the pages that were missing in the download from machinemanuals. Thanks!  |
|
#2
08-21-2009, 09:23 PM
| |||
| |||
| Do you have the 5VDC at the power supply above the logic boards? Can you find it on the back plane (it swings down)? Or is the issue isolated to the BSP? George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
08-22-2009, 06:07 PM
| |||
| |||
| I have 4.7 volts on the backplane and across the LED but it won't light. All of the other lights seem to be happy. The problem on the machine is: On boot up, it will take me to homing and when I execute it will take the spindle all the way up in Z and move the table about an inch to the right in X and then the drives kick out. In jog mode X will run continuously in .1" mode and Z will only travel 2" total. Y seems to work correctly. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| missing section of manual | candylyn | Bridgeport and Hardinge Mills | 0 | 03-09-2007 09:01 AM |
| 5 volts to 1.5 volts? | ZipSnipe | General Electronics Discussion | 5 | 08-18-2006 05:18 AM |
| Boosting three-phase 240 Volts to 480 Volts | Old Car Guy | Phase Converters and VFD | 6 | 05-01-2006 09:27 AM |
| Arrow, Page Up & Page Down Keys - Rhino Video Tutorial | Robert Schutz | Rhino 3D | 0 | 04-25-2006 10:09 AM |
| NC reading tool length from offset page, not data page..? | RMagnusson | Mazak, Mitsubishi, Mazatrol | 1 | 03-21-2006 04:07 PM |
| | |
Linear Mode
