| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-28-2009, 04:15 PM
| |||
| |||
Help.......I have a Heidenhain 151 control. I also have ezcam express v 16. Also have a moxa uniport 1110 usb to serial adaptor. Am having no luck in communicating from my pc to my 151. Have rewired 9 pin to 25 pin per the ezcam manuel, and they still will not communicate.. I would greatly appreciate any feed back I can get. Thankyou.::  |
|
#2
07-28-2009, 07:28 PM
| |||
| |||
| I have had a pile of difficulty myself with USB to serial adapters. Recently trying to set up servo driven auto doors on CNC machines. Had to revert to a old laptop with a COM port. Problem went away. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Communication Error | the_new_girl | PlasmaCam | 1 | 11-24-2008 05:43 AM |
| Need help with communication. | AceikTool | EDM Machines | 4 | 09-30-2008 01:33 AM |
| PC<->NC communication | loky | Mazak, Mitsubishi, Mazatrol | 1 | 03-27-2007 03:44 AM |
| Milling Angle Headache! | ADVANCED MACH. | General Metalwork Discussion | 9 | 12-06-2005 07:46 PM |
| Communication Problem | Alex S.A | Computers and Networking | 2 | 01-28-2005 09:38 AM |
| | |
Communication Headache! 
Linear Mode
