Newbie Upgrading controls with Camsoft - CNCzone.com-The Largest Machinist Community on the net!

Trump · #1 07-06-2009, 08:08 PM

Has anyone used Camsoft software and Hardware to upgrade the controls on
a BP cnc R2C3 mill and if so how did it work out for you I have been talking to
them and might get their package its around $ 2800.00 or is there a better way ? Thanks Earl

greggv · #2 07-06-2009, 08:38 PM

I looked at Camsoft a long time ago, and didn't like it. I've heard some real horror stories about them. Look at Delta Tau, it's much better stuff, maybe a little more involved, but the end result will be worth it!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Upgrading	Captn_tyler	Smithy	3	06-06-2009 02:50 PM
PC Controls vs. Industrial Controls	Billiam	General CNC (Mill and Lathe) Control Software (NC)	0	03-16-2009 08:54 AM
Need Help!- Upgrading from X to X3	tumchie	Mastercam	3	01-03-2009 03:50 PM
Upgrading my Tree	Tom Curran	CamSoft Products	1	10-20-2008 01:10 PM
Upgrading a 1993 VF3????	sco999	Haas Mills	1	04-14-2007 02:06 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)