| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-28-2009, 04:52 AM
| |||
| |||
Hello , I want to use my BP Eztrak 2 CNC for PCB Milling . I have a highspeed spindle powerd with pressure air . Can i make a cnc operation without switch on the mainspindle ? Greetings Hans  |
|
#2
06-28-2009, 01:59 PM
| |||
| |||
| The control allows rapid moves without the spindle ON. Feed rate moves meeds a verification that the spindle is on. All you have to do is allow the contactor to close without power going to the spindle motor. An auxiliary set of contacts tells the control that the spindle is on. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Offset Chain Milling vs Path Milling | ynnek | TurboCAD/CAM | 1 | 03-11-2009 05:29 PM |
| Milling Help | ligito | General Metal Working Machines | 1 | 02-27-2009 04:30 PM |
| PCB milling | Psytron | Australia, New Zealand Club house | 8 | 02-25-2009 04:04 PM |
| Milling with bottom vs milling with side? | REVCAM_Bob | CNCzone Club House | 13 | 06-30-2008 09:23 AM |
| G41 to G40 Milling | Kiwi | General CNC (Mill and Lathe) Control Software (NC) | 2 | 09-06-2006 02:01 AM |
| | |
Linear Mode
