EZ Trak DX

[custom]

while using went to zero axis , and nothing happened, pushed reset button and now all I get is "memery test OK" and "hard disk fail". This machine has a hard drive and Z axis installed. went in and changed format to A,C instead of C,A nothing any different. cmos seem to be correct, I am not a computer wizard by any means!! so not sure what to do, this site has been very helpful in the past. any help would be great. Thanks

[idtkid]

Unplug and replug in the hard drive, make sure its power connection is properly seated as well? This isnt EZ Trak specific advice, just my experience with PCs