| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-20-2009, 08:46 AM
| |||
| |||
Could someone explain to me the full purpose of the drawbar proximity sensor on the series 2 interact 4 and the method in which it is used ? The maintainence manual talks about it preventing the spindle starting with an incorectly engaged tool. But what does this mean? It even suggests to intentionally incorrectly engage a tool as a means of testing correct operation of the sensor. What I would like to know is how to incorrectly engage a tool for the purpose of this test? From my experience so far a tool is either locked in or not held at all. I have failed to some accross an inbetween state of held in but not quite proper.
__________________ Dom http://www.ukrobotics.com/projects  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- series II interact 4 acting up! | spock | Bridgeport and Hardinge Mills | 0 | 12-01-2008 09:16 AM |
| Newbie- Interact 1 Series ll | JRS | Bridgeport and Hardinge Mills | 2 | 02-01-2008 06:21 AM |
| Bridgeport Interact Series II Power Drawbar | UKRobotics | Bridgeport and Hardinge Mills | 9 | 09-15-2006 07:27 PM |
| Series 2 Interact Power Drawbar | UKRobotics | Bridgeport and Hardinge Mills | 2 | 07-14-2006 10:56 AM |
| Drawbar For Bridgeport Series I R2e4 | synergymc | Bridgeport and Hardinge Mills | 1 | 08-24-2005 07:22 PM |
| | |
Linear Mode
