Heindenhain tnc 351 for sale complete

[capsteve]

I bought an interact 412 from a small job shop for the express purpose of upgrading the controller to something modern. The unit was run before purchase and confirmed everything worked (by 1989 standards) Now that the conversion is nearly done i'm going to sell the components that were removed.
Heres what i have
1, the main processor unit
2, video display unit
3, numeric keypad unit with gcode overlay pad
4, (3) heindenhain axis servos with encoders
5, bosch axis controll unit with 3 servo amplifiers and power supply

i'd like to sell together, but i'm open to discuss parting out
also if anyone has any idea what this stuff is worth i'd appreciate any input.

p.s. i went with a camsoft based conversion with servo dynamics servos/drives and roll my own control panel. just finishing up on toolchanger logic and some other small software issues. overall its been a great learning experience. I'll write a report once its all done.

[Jurek]

I have 87 INT 412 with 151 cntr. Do you think Bosch axis unit the same. I would like to have a spare.Jurek