Newbie Advice on purchase of Bridgeport series I with BOSS controller - Page 2 - CNCzone.com-The Largest Machinist Community on the net!

tpmx57 · #13 03-29-2009, 07:21 PM

I hav Series II with the Boss 6.
I switched it over to the board Darek sells 2 years ago.
Running Mach 3 and have never looked back.
I ran the Boss 6 for about 2 weeks and it was just too involved to do simple things on.
It would do the job but this setup is light years better.
Hats off to Bridgeport for building these great machines,just put a little better control on them and throw some chips!
Heres a photo of mine:http://www.hitechhobbies.com/Machines.html

JimPAC · #14 03-31-2009, 06:27 PM

Leo,

Don't listen any ney Sayers on old BP iron!

You have a good deal going and you can get all you need to get it up and going right here on the ZONE!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
bridgeport series 2 cnc boss 6	MR Custom	Bridgeport and Hardinge Mills	27	12-22-2011 08:52 PM
bridgeport series 1 boss 6	MR Custom	Bridgeport and Hardinge Mills	11	11-19-2007 07:04 AM
Help...BRIDGEPORT SERIES 1 BOSS...I need advice	gijoe	Bridgeport and Hardinge Mills	5	09-12-2007 02:53 PM
Bridgeport Series I Boss 4	millwrightguy	Bridgeport and Hardinge Mills	6	06-27-2007 08:07 PM
Bridgeport Series I Boss 5 Controller	VIC H	General Metal Working Machines	0	07-24-2006 11:54 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)