| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-18-2009, 05:11 PM
| |||
| |||
We have a TC1G that homes xy&z ok but the Carousel isnt moving anymore.. i get an alarm message "TlChg: Carousel Timeout"... cant do any toolchanges.. any ideas on how to correct this or manually open and rotate Carousel.. Thanks TOM    |
|
#2
03-19-2009, 08:46 AM
| |||
| |||
| What control? Assuming DX control There is a IO module for the tool changer. Power comes in on J10 and J11. There are no external contactors or relays. This board controls the power to the tool carossel motor and tool arm motor. It should have LED on it to tell you if a output is turned on. If LED is on, power is there, and no output you may have a bad component on the board. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carousel Out of Position Error | FRONTIER | Bridgeport and Hardinge Mills | 4 | 08-24-2008 11:32 PM |
| Carousel Problems! | gamila | Fadal | 2 | 01-04-2008 09:41 AM |
| Carousel Problems | gamila | Fadal | 2 | 11-06-2007 11:52 AM |
| carousel, turret or magazine | mjiba | General Metal Working Machines | 2 | 10-14-2004 06:07 PM |
| | |
Linear Mode
