Hi hrhoward
I don't no how to help you with votage, but it does look like something has gone bad, I may be able to help you with some parts from one I have here post a photo of which power supply you need, I know the one I have was working
I think I have a bad logic power supply on a Series I R2E4. I have 125 vac going in but only +/- .72 vdc where I should have 12 and only .2 vdc where I should have 5. Power supply bad or is the ac in to high?
Thanks.
Hi hrhoward
I don't no how to help you with votage, but it does look like something has gone bad, I may be able to help you with some parts from one I have here post a photo of which power supply you need, I know the one I have was working
Mactec54
Mactec54,
Here is a link with a photo.
Power Supply
Hi hrhoward
I looked at your photo & checked what I had left & most of the R2E3 & R2E4 Parts are all gone there is some older Boss5 power supplys left & that is it I hope you can find something or you could repair the one you have
Mactec54
I have one you can purchase for $90.00
It came off my working R2E4 Boss 9
Last edited by CNCadmin; 05-09-2012 at 01:51 PM.