Logic Power Supply Bad? R2E4 Series I - CNCzone.com-The Largest Machinist Community on the net!

hrhoward · #1 03-18-2009, 11:52 AM

I think I have a bad logic power supply on a Series I R2E4. I have 125 vac going in but only +/- .72 vdc where I should have 12 and only .2 vdc where I should have 5. Power supply bad or is the ac in to high?

Thanks.

mactec54 · #2 03-18-2009, 12:12 PM

Hi hrhoward

I don't no how to help you with votage, but it does look like something has gone bad, I may be able to help you with some parts from one I have here post a photo of which power supply you need, I know the one I have was working

hrhoward · #3 03-19-2009, 11:05 AM

Mactec54,

Here is a link with a photo.

Power Supply

mactec54 · #4 03-19-2009, 10:39 PM

Hi hrhoward

I looked at your photo & checked what I had left & most of the R2E3 & R2E4 Parts are all gone there is some older Boss5 power supplys left & that is it I hope you can find something or you could repair the one you have

dirtdiggler · #5 03-23-2009, 01:24 PM

I have one you can purchase for $90.00

It came off my working R2E4 Boss 9

email me at kirkswanson@hotmail.com if your interested.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newbie- Series I power supply	marvfrankel	Bridgeport and Hardinge Mills	9	02-24-2008 09:08 PM
Is there a good place to buy a used Logic Power Supply	Bill Gillen	Bridgeport and Hardinge Mills	1	10-01-2007 09:56 PM
Cursader Series M power supply burned..	Danii	General CNC (Mill and Lathe) Control Software (NC)	0	11-28-2006 08:44 AM
R2E4 logic power supply	jeep534	Bridgeport and Hardinge Mills	4	10-24-2006 12:43 AM
Power supply for Bridgeport Series II	Billy Bird	Bridgeport and Hardinge Mills	3	01-05-2006 08:58 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)