Need Help! bridgeport interact 4 series 2 - CNCzone.com-The Largest Machinist Community on the net!

gideon233 · #1 02-13-2009, 04:54 AM

hi,
just a newbie with limited knowledge of heidenhain 155 controls, im trying to program 110 holes on 211 P.C.D, av got the majority of the program done but it in the programming manual it says put it LP but theres no LP button on the machine, can someone help me and tell me what the solution is to program the holes?

many thanks bill

gus · #2 02-13-2009, 07:33 AM

L, key, polar mode[P key]

Jurek · #3 02-13-2009, 07:17 PM

I think LP means / linear polar interpolation. First press CC key /Xand Y cyrcle center/ Next block press Yellow key''P'than ''L'' key /key in distance.radius and starting angle.Jurek

gideon233 · #4 02-15-2009, 08:05 PM

many thanks to gus and jurek
best regards
bill

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bridgeport Series II Interact 2 problems	gugu	Bridgeport and Hardinge Mills	24	01-10-2011 07:34 AM
Need Help!- Bridgeport interact series 1 axis run-away	AbsoluteMTS	Bridgeport and Hardinge Mills	2	11-05-2008 06:48 AM
Need Help!- Bridgeport Series 1 interact tnc 145	jaztau	Bridgeport and Hardinge Mills	2	10-20-2008 04:12 AM
Need Help!- Bridgeport Series 1 Interact	zorba99	Bridgeport and Hardinge Mills	7	06-11-2008 07:59 AM
Bridgeport series 1 Interact schematics	Mike Conboy	Bridgeport and Hardinge Mills	13	03-13-2006 09:32 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)