Need Help! Bridgeport Explorer I Boss DX32 - CNCzone.com-The Largest Machinist Community on the net!

minton · #1 02-11-2009, 09:39 PM

I recently purchased a 1997 Bridgeport Explorer I with the Boss DX32 control. I have the DX32 Programming Manual and the DX32 Operators Manual, V2XT/Explorer I. I have no experience on this machine. I do have limited experience on an Okuma LB25 Lathe and several CNC Milling Machines. However, it's been quite awhile, so I'm out of practice and rusty. Any help getting started would be greatly appreciated.

Many Thanks!

minton

tpmx57 · #2 02-12-2009, 07:09 PM

I have a torgue cut 22 that has the dx32 control.
I am not sure if its similar to yours but found it was a very easy control to figure out.
If they are close I would help what I can.
let me know

minton · #3 02-12-2009, 11:12 PM

tpmx57:

Thanks for your reply. I'm already encouraged that you said it was an easy control to learn. I would really like to talk with you. Please send me your name and phone number and the best time to call.

Regards,

Bob

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Bridgeport DX-32 (Explorer I) / Conversion	aogonzalez	Servo Drives	2	01-30-2009 02:05 AM
Bridgeport DX32 post	Chris Rand	Post Processor Files	2	11-19-2008 04:27 PM
BridgePort Explorer X-26 Gear Range Issue	Lesleh	Bridgeport and Hardinge Mills	2	11-30-2005 07:27 PM
Bridgeport Explorer CNCs	arsenix	Bridgeport and Hardinge Mills	9	02-10-2005 06:28 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)