R2E3 Series 1 - CNCzone.com-The Largest Machinist Community on the net!

Tommy · #1 11-08-2008, 12:04 PM

My B.P is blowing #19 and #20 fuses as soon as power is applied. I think they feed the 100v Power Supply. Anyone ever had this Problem?

Sure could use some feedback.
Thanks
Tommy

greeder88 · #2 11-08-2008, 12:24 PM

Look for burned components on the "Logic Power Supply" which is the upper right board in the side cabinet. I have had those go out for no apparent reason.

Tommy · #3 11-08-2008, 02:48 PM

Thanks for the Reply.

I checked the Board looks good, machine powers up screen looks good, shows no errors,
red light on axis button stays on after trying to home you will hear the enable relay kick out. Thats when I found the two fuses shot.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
R2E3 Series II - How to communicate with it?	bellamyj	Bridgeport and Hardinge Mills	9	09-29-2008 09:24 AM
R2E3 Series I CNC	krz2_2000	Bridgeport and Hardinge Mills	4	08-03-2007 01:30 PM
Series 2 r2e3 control retrofit	cut more	Bridgeport and Hardinge Mills	6	05-09-2007 09:09 AM
R2E3 series 1 Boss 8 interest	s1j1m10	Bridgeport and Hardinge Mills	1	08-23-2006 10:53 AM
Series 1 R2E3 Questions	BSU130	Bridgeport and Hardinge Mills	3	03-28-2006 08:42 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)