Bridgeport clock spring - CNCzone.com-The Largest Machinist Community on the net!

seiz0r · #1 11-03-2008, 08:03 PM

I took the cover off of the quill and the clock spring cover spun.Is there any special way to adjust it back to where it was? Thanks Gerry

tommied · #2 11-03-2008, 08:57 PM

one and a half turns. tommie

seiz0r · #3 11-03-2008, 09:23 PM

from it being fully unwound?

Ryobiguy · #4 11-03-2008, 09:32 PM

Yes, that is what the manual says.

Or you could unwind it an extra 1.5 revolutions, and give it a 3 full turns from there. ;^)

-Matt

seiz0r · #5 11-03-2008, 10:37 PM

Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
another clock	balsaman	WoodWorking	49	05-13-2009 08:17 PM
A cnc clock	balsaman	WoodWorking	69	01-26-2008 01:15 PM
Looking for CNC Plasma Clock dxf	zeoncomp	CNC Plasma and Waterjet Machines	1	01-09-2008 06:42 PM
alarm clock	D5zUga	Rhino 3D	0	10-15-2004 05:54 PM
MasterCam Clock	DDM	WoodWorking	4	08-08-2004 08:27 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)