Need Help! Blockwise transfer,drip feed on Tnc 2500. - CNCzone.com-The Largest Machinist Community on the net!

Paul cs · #1 08-30-2008, 08:25 PM

Need help with drip feed on series 2 interact 2.
Not had the machine long and can transfer to and from the control in the EXT mode with Bobcad V21.
But try to change parameter's for Blockwise transfer and can no longer send or receive files, anyone know where to start ?.

Thanks in advance.
Paul.

gus · #2 09-02-2008, 09:45 AM

no experience with this particular control, but most heidenhain are 7 bit even parity 1 stop bit. I run no flow control, and start out with 2400 or 4800 baud, just what ever matches your computer for baud

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Drip Feed	kirby	Fanuc	23	10-20-2008 10:21 AM
Drip feed?	kotten1	Mazak, Mitsubishi, Mazatrol	5	07-08-2008 03:44 AM
Drip feed?	MrWild	Dolphin CADCAM	1	02-24-2008 11:33 PM
BMC-20 w/Max II drip feed......	GPena	HURCO	6	10-31-2007 01:37 PM
Drip Feed	camtd	Surfcam	0	07-31-2006 07:09 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)