Problem- HEIDENHAIN TNC 145

[zknives]

NEED HELP WITH BP SERIES 1 R2C3 WITH HEIDENHAIN TNC 145. I JUST PLUGED IT UP. I HAVE JUST A LINE ACROSS THE MONITOR BUT I DO HAVE 0"S ACROSS THE XYZ READ OUT AND ALL OF THE RED LIGHTS ON THE CONTROL ARE ON . WHAT DO I DO NOW. I RUN A BP SERIES 1 WITH AN AHHA CONTROL. BUT THIS CONTROL IS NEW TO ME.

[gus]

"CE"

Power enable [should hear a loud thump]

Turn the brightness or contrast knobs on the monitor so you can read it.

cycle start for each axis till it homes[up to six times]

look at the pretty machine

turn the power off

GET A MANUAL!!!!!!!

I may have a programming manual to spare..........

[gus]

Actually Heidenhain.com, 'OMA controls' and download one.

You ought to have the r2c3 manual though, they do turn up on ebay

[machintek]

A line across the screen usually means a defelction amp in the CRT is gone.
There is a horizontal and verticle deflection amp that bends the beam and paints the phosphors on the CRT making a display. A line means the beam is deflecting in one plane only.

George.

[zknives]

THANKS, I AM AT THIS POINT JUST TRYING TO POWER IT UP AND SEE IF ALL OF THE AXIS WORK. I DID HAVE THE SPINDLE RUNNING BUT WAS NOT ABLE TO MAKE THE X Y Z MOVE WITH THE JOY STICKS . I DID TAKE THE 3 AA BATT. OUT AND CHECK TO SEE IF THEY WERE OK BUT NOW I CANT GET THE CLEAR BUTTON (CE) TO TURN ALL OF THE RED LIGHTS OFF SO I CAN POWER THE SPINDLE UP.

[gus]

That is because you did not READ. You have now lost all of your parameters. good job.
Look in the archives, I think I posted a set at some time in the past

GET THE FREAKIN BOOK