| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-15-2008, 11:32 PM
| ||||
| ||||
Hey gang, here's a picture of my 19" lcd retro fit to my V2XT. I just finished cutting out the stainless panel. Did all the lettering on the mill as well. Too bad I didn't think to do the "start" "enable" etc etc lettering too.........  Peace 
__________________ 9 1/2 B.C.I.T. Machinist CNC  |
|
#3
06-16-2008, 08:15 AM
| ||||
| ||||
| Nice Job  BTW, did you put any protective shield over the LCD? Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
|
#4
06-16-2008, 07:03 PM
| ||||
| ||||
| Thanks guys. I'm probably going to pull it off and put the other lettering on it. The felt pen is sort of an eye sore. Al, i didn't put any cover over the LCD. At this point, there is no coolant or other issues getting over there. What do you recommend? Do you think "window film" would work? You know like the oil change stickers? Owen
__________________ 9 1/2 B.C.I.T. Machinist CNC |
|
#5
06-16-2008, 09:32 PM
| ||||
| ||||
| I use a material recommended for use with shop LCD's it is Acrylite FF P-99 anti-glare finish. I usually buy it by the 1/2 sheet, but a local plastic supplier may oblige with a smaller piece. Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- I NEED a V2XT DX-32 " User Manual " BAD!!! | v488 | Bridgeport and Hardinge Mills | 4 | 03-17-2008 05:53 AM |
| V2XT error message "DRIVE FAULT detected (0,z,y,x) check log" | rfdoyle | Bridgeport and Hardinge Mills | 4 | 10-08-2007 03:35 PM |
| How/what machine to shape a thin stainless plate to become a "half" egg shape ? | Calico | General Metalwork Discussion | 5 | 03-24-2007 09:40 AM |
| V2XT Control Panel Updates | NEATman | Bridgeport and Hardinge Mills | 0 | 10-05-2006 11:32 PM |
| Wanted; V2XT way wiper " the rubber one" | v488 | Bridgeport and Hardinge Mills | 1 | 02-12-2006 12:05 AM |
| | |
Linear Mode
