Need Help!- Bridgeport Series 1 Interact

[zorba99]

I am new to this forum and need help from you guys, please.
I desperatly need machine parameters, because my buffer batterie's wire came loose and now all the info is lost. Please help urgently.The parameters I need is for the TNC 145 controller.

[gus]

something very close has been posted on this board before.

[zorba99]

I know that some people have asked the same question about the machine parameters, and a couple of guys told them that they have the parameters and will e-mail it to them, but no parameters found on the forum itself. Please, if anyone's got it, please send it to me.

[gridley51]

Zorba,have you got an email address?

Mark.

[zorba99]

Originally Posted by gridley51 Zorba,have you got an email address? Mark.

My e-mail address: rigorindustries.christo@telkomsa.net

[gus]

If you are too lazy to actually search the forums, you will have trouble keeping the machine running

just a start, I have other things to do

http://www.cnczone.com/forums/showth...t=51625&page=2
http://www.cnczone.com/forums/showthread.php?t=33292

[zorba99]

Those parameters are for the R2C3 and not Interact. I've got an Interact. And yes, I did search the forums, and I got no parameters for the Interact. Thanks

[gus]

The only substantive difference between the parameters between the two are approach direction for referencing and then the travel limits in y and maybe x. both sets of parameters are there, on for an interact with a 151, and one for the r2c3, so you have everything you need.