Ez trac sx wiring - CNCzone.com-The Largest Machinist Community on the net!

999le · #1 06-10-2008, 12:22 AM

I'm looking for the electrical drawings . I need to rewire from 460 to 230 volts. the motor controls are no problem to figure out. I need to change the jumpers on the transformer and don't have any drawings.
Lynn

doctordemo · #2 06-11-2008, 01:22 AM

I don't know for sure that the SX and the DX are the same in reguards to the transformer, but I had to change from 208 to 220 so I know I have that info somewhere.
If no one beats me to it I will look tomorrow when I get home.
Steve

machintek · #3 06-11-2008, 07:21 AM

I have a scan of EZTRAK-SX wiring but it is over 1 MB in size. I need a email address.

George

999le · #4 06-12-2008, 12:57 AM

Originally Posted by machintek

I have a scan of EZTRAK-SX wiring but it is over 1 MB in size. I need a email address.

George

got the email,

thanks a bunch

999le · #5 06-12-2008, 12:59 AM

Originally Posted by doctordemo

I don't know for sure that the SX and the DX are the same in reguards to the transformer, but I had to change from 208 to 220 so I know I have that info somewhere.
If no one beats me to it I will look tomorrow when I get home.
Steve

Thanks for the response Machintek sent me a copy of the drawing

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bridgeport EZ-Trac post processor	got_woody	Post Processor Files	2	02-11-2007 03:24 PM
ez trac voltage issue?	plkelly	Bridgeport and Hardinge Mills	4	05-16-2006 05:05 PM
How to repeat a EZ-Trac Program	Stoney372	Bridgeport and Hardinge Mills	4	02-16-2006 01:24 PM
ez-trac problems	Dan D	Bridgeport and Hardinge Mills	8	06-26-2005 07:09 PM
Wiring help.	dmgdesigns	General Electronics Discussion	3	04-16-2005 11:12 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)